Auto Oil Primer Brown

It is an anti-corrosive base coat designed to protect metal surfaces, auto chassis, and commercial vehicles from rust and corrosion.

No, it is a single-pack (1K) oil-based primer, meaning it air-dries naturally without a hardener.

Always mix it with high-quality AngelCoat Synthetic Thinner (Enamel Thinner) for a smooth finish and proper drying.

Add 10% to 15% thinner by volume to achieve the perfect consistency for brushing or spraying.

It is highly versatile and can be easily applied using a spray gun, a brush, or a roller.

Being an oil-based primer, it takes about 1 to 2 hours to become surface-dry (dust-free).

It requires 12 to 24 hours (overnight drying) to become fully hard and ready for sanding

Once fully dry, lightly sand it with 320-grit or 400-grit sandpaper to make the surface perfectly smooth for the topcoat.

Apply 1 to 2 even coats depending on the condition of the bare metal and the level of rust protection needed.

It acts as the perfect, strong base for AngelCoat Synthetic Enamel Paints and other alkyd-based auto paints.

No, the strong solvents in NC (Nitrocellulose) or PU paints will cause this oil-based primer to wrinkle, lift, or peel off.

This happens if you apply the primer coat too thick, or if you use cheap, slow-drying solvents like kerosene instead of proper Synthetic Thinner.

Thoroughly sand the metal to remove all existing rust, oil, grease, and dirt, then wipe it completely clean to ensure the primer grips the metal tightly.

Angel Coating Auto Oil Primer Brown is supplied across several states in India, including Gujarat, Rajasthan, Punjab, Uttar Pradesh, Madhya Pradesh, Chhattisgarh, Goa, Kerala, Tamil Nadu, and Karnataka.